G200w Vac and water lines

katq22 · Post by **katq22** » 11 Dec 2007, 11:41

Ok now that the motor runs i need to work out the plumbing properly Does anyone have any close pics of the inlet manifold with vac lines attached? I haven't been able to find any clear ones of complete motors also where does the water come from for the throttle body?

Thanks

Ben

bad 44u · Post by **bad 44u** » 11 Dec 2007, 18:07

keep it simple block everything off. you only need 1 vacum line from the dizzy if it has vacum advance and one to the computer if its an aftermatket and these go on to the plenum chamber. water 1 in and 1 out to the radiator and 1 in 1 out for the heater if you hook it up.

katq22 · Post by **katq22** » 11 Dec 2007, 23:30

I realize that but I need to have it looking stock for registration and hoses hanging off with bolts in them (as it is now) does not look factory. which one is the vac line for the brake booster??
Thanks Ben

bad 44u · Post by **bad 44u** » 12 Dec 2007, 08:26

rather then use hoses with bolts remove the plugs where the hoses join with blanking bungs. i used anodized allen key ones or cut them off and weld them up. the brake booster should connect on the bottom of the inlet manifold around cylinder 4.

Post by **elky** » 12 Dec 2007, 14:04

i have never seen a "water" cooled throttle body, maybe i have missed this?

my zz/r and zz/t certainly dont have this, i wil check my 117 coupe motor but that has a forward facing t body, what type of intake do you have?

cheers

katq22 · Post by **katq22** » 14 Dec 2007, 10:43

I was told by my mate that its not for cooling but heating (can be seen in pic four). I have some pics of my motor. from what i can tell Its is a bit of a bitsa. It looks like a 117 motor , Itec Manifold (Also have 117 forward facing) and an ECGI computer.

GeminiCoupe · Post by **GeminiCoupe** » 25 Dec 2007, 21:23

Does look like a 117 motor with what looks like a JR130 inlet manifold and dizzy...

Greengem20B · Post by **Greengem20B** » 08 Jan 2008, 12:33

Hope this pic helps you in some way....

Wasnt sure if this is what you are after and if my vacuum lines were plumbed right though thats how it came out of the car...

Good Luck!

Todd.