Electronic Dizzy

[DDH3]

Can some one tell me how to wire this dizzy? I would like to use it in place of a stock points type.
Also where might I find A cap and rotor, can I find them on any other cars?

[bad 44u]

it looks like it might need a tidy up. also you want to see if there is a module inside connected if so one pin goes to possitive and one goes to the negative side of the coil i think. if you've got a points coil you'll need to replace it or atleast remove theballastresistor.

[Greengem20B]

Try these parts from an early Pulsar....

Dizzy Cap - Part #GH604

Rotor Button - Part #GH605

Only thing is the button hasnt got the screw on the side to hold it on the shaft.I used a blob of Sikalfex to hold a mates in place,hasnt had any dramas.

Hope that helps

Todd.

[IZU069]

I know it's bumping an oldie...

The ignitor has C & B marked for Coil (-) and Battery (Ignition +12V) respectively.

But replace the whole dizzy with a modified Gemini dizzy.
You can fit RB reluctor guts to that for a virtually indestructible dizzy & ignitor.